Extrusion Press Container and Liner Change
Containers and Liner change are the most expensive tools in extrusion.
The design, material and manufacture of the containers and Liner change
are therefore of special importance.
The high stresses occurring in the containers and Liner change are mainly
- Deformation loads
- Thermal stresses and wear.
TRAMAK takes all of these factors fully into account.
We meet the high demands on “critical tools” with our special expertise.
In addition to material selection, the container and Liner Change design is of special importance.
This is where the specialised knowledge of TRAMAK comes into its own, because design is part of our daily business.
This applies similarly to complex temperature control as required for modern zone-heated and cooled containers.
TRAMAK MACHINE ‘s technology, product and system expertise in terms of continuous improvement is obvious.
The following table shows the materials used for individual container and Liner change components.
This includes the materials for processing aluminium, copper and copper alloys.